24
③Status indicator
Note:
• Lighting/blinking LED can be turned off with the software settings at any time. (The initial state
is lighting or blinking.) Set the LED to be solid off if necessary, depending on the installation
conditions. (☞ Operating instructions included in the CD-ROM)
• When the power is on, initialization may start with orange blinking.
⑴ When the SD ON/OFF button is pressed (less than 1 second), the SD MOUNT indicator lights
up in green and data can be saved to the SD memory card.
⑵When the SD ON/OFF button is held down (about 2 seconds), the SD MOUNT indicator lights
off and the SD memory card can be removed.
④SD ON/OFF button
Operation status Indicator status
When the power
is turned on
Before the network connection
is established
Lights orange → Lights off → Blinks orange →
Lights orange
When the network connection
is established
Lights orange → Lights off → Blinks orange →
Blinks green → Lights green
During the standby
or connection
Cable is not connected Lights orange
Cable is connected Lights green
During the upgrade process Blinks orange
Initialization (When the network connection is
established)
Lights orange → Lights off → Blinks orange →
Lights orange → Blinks orange → Blinks green
→ Lights green
Port forwarding error caused by the UPnP function Blinks orange (in 2 seconds intervals
(on for 1 second / off for 1 second))
Trouble happening on the camera Blinks red
Failure in writing data on the SD memory card Lights red
To Next Page
Loading...
