14
Precautions for installation
Installing place
Contact your dealer for assistance if you are
unsureofanappropriateplaceinyourparticu-
larenvironment.
• Make sure that the installation area is
strong enough to hold this product, such
asaconcreteceiling.
• Installthecamerainthefoundationareaof
thearchitectureorwheresufficientstrength
isassured.
• If a wall or ceiling board such as plaster
board is too weak to support the total
weight, the area shall be sufficiently rein-
forced.
Do not place this product in the following
places:
• Locationswhereachemicalagentisused
suchasaswimmingpool
• Locations subject to oil smoke such as a
kitchen
• Locationsthathaveaspecificenvironment
that is subject to an inflammable atmo-
sphereorsolvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
fieldisgenerated
• Locations where corrosive gas is pro-
duced,locationswhereitmaybedamaged
bybrinyairsuchasseashores
• Locations where the temperature is not
withinthespecifiedrange(
☞ page40).
• Locations subjectto vibrations(This prod-
uctisnotdesignedforon-vehicleuse.)
Be sure to remove this product if it is not
in use.
Design and engineer the power supply
system to turn on/off the power of this
product.
The product has no power switch. When
installing the product, use a power supply
device equipped with the ON-OFF switch for
servicing.
About the network connection
Whenconnectingtoanetworkusingthenetwork
cableofthisproduct,observethefollowing.
• When wiring for the network, design and
engineernottobeaffectedbythunder.
• It is impossible to install this product in
combinationwithapan/tilthead.
Screw tightening
• The screws and bolts must be tightened
with an appropriate tightening torque
according to the material and strength of
theinstallationarea.
• Do not use an impact driver. Use of an
impact driver may damage the screws or
causetighteningexcessively.
• Tightenscrewsatarightangletothesur-
face.Aftertighteningscrews,performvisu-
al check to ensure tightening is so suffi-
cientthatthereisnobacklash.
The measures of protection against a fall
of this product shall be taken.
Failuretoobservethismaycauseadropresulting
ininjuryoraccidents.Besuretoinstallthesafety
wire.
Procure fixing screws separately.
The screws that secure this product are not
supplied.Preparethemaccordingtothemate-
rialandstrengthoftheareawheretheproduct
istobeinstalled.
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.