Panasonic WV-SW316L

33
<WV-SW316L/WV-SW316>
Mount the front cover.
<WV-SW314>
Attach the desiccant (accessory) to the inner bottom side of the front cover along the guide rib, and
mount the front cover.
Desiccant (accessory)
Guide rib
Fixing screw x4
(3)
(1)
(2)
(4)
IMPORTANT:
 • Besuretoattachthedesiccant(accessory).Refertotheinstructionsforthedesiccantforhow
to attach it.
SW314
 • Thetighteningtorquedescribedbelowshallbefollowedforthe4fixingscrewsoffrontcover.
Recommended tightening torque: 0.59 N·m {0.44 lbf·ft}
 • Thetighteningsequenceofthe4fixingscrewsofthefrontcovershallbeobservedandrepeat-
ed twice as described in the illustration above.
((1)
→
(2)
→
(3)
→
(4), twice)
 • Make sure the packing has not come off or become askew. If this happens put it back into
place.
 • Makesurethepackinghasnodustorothercontaminantsonit.Removeanydustorcontami-
nants on the packing.
 •
Remove the cover film from the clear part of the front cover section after the installation is complete .
Do not touch the clear part of the front cover section by hand directly after removing the cover film .
Mounting the front cover
Fixing screw x4
(3)
(1)
(2)
(4)