Panasonic WV-SW316L

35
b Mount the tripod head on the top of the camera body with the 4 tripod head mounting screws
that were removed in the step 2.
IMPORTANT:
 • Cautionshallbetakentopreventeachcablefrombeingcaughtbetweenthecamerabodyand
tripod head.
 • Besuretousethescrewsthatwereremovedfromthetripodhead.
Recommended tightening torque: 0.59 N·m {0.44 lbf·ft}
n Secure the camera to the camera mount bracket with the camera fixing screws x3 (accessory).
Pass each cable and the safety wire through the camera mount bracket, and connect the safe-
ty wire to the camera mount bracket. Then, bundle the wire and the cable using the cable
clamp and secure them with each screw from the mounting boss to the camera mount bracket
(
☞ page 20-21).
Camera main body
Tripod head fixing screw x4
(M3x10)
Camera fixing screw x3 (M4 x 8)
(accessories)
Camera mount bracket
IMPORTANT:
 • Besuretousethescrewsthatwereremovedfromthecameramountbracket.
Recommended tightening torque: 0.78 N·m {0.58 lbf·ft}
 • Besuretousethescrewsthatwereremovedfromthesafetywire.
Recommended tightening torque: 0.59 N·m {0.44 lbf·ft}
(This illustration represents WV-SW316.)