4. Configure the settings of Camera 2 (IP address: 192.168.0.12), which receives notification commands from
the other cameras.
Display the “Alarm” screen from the “Alarm” page. (®page 134)
From “Alarm”, set “Command alarm” to “On” and click the [Set] button.
Set the “Command alarm” of “Camera action on alarm” to “Preset per sender”, and click “Preset per
sender >>”.
On the “Preset per sender” setup menu (®page 137), check the “Auto track cooperation” checkbox
of “Sender's address 1” (any destination address can be used) and enter 192.168.0.11 (Camera 1) for
the sender’s address. Then select the preset position set at step 2, click the [Set] button, and then close
the page.
Click the [Set] button.
5. Auto track cooperation can be used by starting the auto tracking for Camera 1.
11.6.7 Configure the settings relating to direction (“Direction”
setup menu)
Click the [Setup>>] button of “Direction” on the [Image/Position] tab of the “Image/Audio” page (®page 99).
Here the information related to the direction setting is set. The pan/tilt position moves to the position set as
north when displaying this page.
Direction setting
[North point setting]
If “Direction display” is selected for “Camera position display”, one of the eight directions will be indicated
instead of the preset position title when the camera is not at the preset position.
Determine the direction setting by adjusting the displayed panning position to the north (N) indication.
[Zoom] buttons, [Focus] buttons, [Brightness] buttons, Control pad/buttons and [Go] button
Refer to page 9 for descriptions of how to operate these buttons/pad.
Operating Instructions 123
11 Configure the settings relating to images and audio [Image/Audio]
To Next Page
Loading...
