Panasonic WV-SW598APJ

15 Configure the settings relating to the
authentication [User mng.]
The settings relating to authentications and restrictions for users and PCs accessing the camera with a PC or
cellular phone/mobile terminal can be configured on the “User mng.” page.
The “User mng.” page has the [User auth.] tab, the [Host auth.] tab and the [System] tab.
15.1 Configure the settings relating to the user
authentication [User auth.]
Click the [User auth.] tab on the “User mng.” page. (®page 47, page 49)
The settings relating to the authentication of users who can access this camera from the PC or a cellular phone/
mobile terminal can be configured on this page. Up to 18 users can be registered.
Note
• When user authentication has failed (authentication error) 8 times within 30 seconds using the same
IP address (PC), access to the unit will be denied for a while.
[User auth.]
Select “On” or “Off” to determine whether or not to authenticate the users.
• Default: Off
[Authentication]
Set the user authentication method.
Digest or Basic: Uses Digest or Basic authentication.
Digest: Uses Digest authentication.
Basic: Uses Basic authentication.
• Default: Digest or Basic
156 Operating Instructions
15 Configure the settings relating to the authentication [User mng.]