Panasonic WX-CH457P - Deleting Registered IDs

English
33
 Deletion of ID
When the Center Module is WX-C3010, delete the ID of this product according to the
following procedure.
 This setting is enabled when the Center Module model selection setting is set to
WX-C3010.
When WX-CC411, WX-CC411A, WX-CC412 or WX-CC412A is set, there is no need to
delete the ID manually. Delete the ID on the Center Module.
1 Rotate the microphone boom to turn off the power of this product.
2
For deleting an ID registered in the Center Module of Lane A
Rotate the microphone boom while holding down the [VOL] and [T] buttons to
turn on the power of this product.
● The unit starts in “Delete ID mode”. The power indicator blinks orange.
For deleting an ID registered in the Center Module of Lane B
Rotate the microphone boom while holding down the [VOL] and [P] buttons to
turn on the power of this product.
● The unit starts in “Delete ID mode”. The power indicator blinks orange.
3 Press the [P] button.
● The ID is deleted instantly, the voice message “ID not registered” is heard from the
earphone, and the power indicator blinks red to indicate an abnormal state.
● If Deletion of ID fails, a beep and the voice message “Failed” are heard from the
earphone, and the power indicator blinks red to indicate an abnormal state. If that
happens, retry from step 1.
 When the number of ID registrations of the headset exceeds the Center Module’s
upper limit, the Center Module deletes some IDs automatically. If a unit of the headset
is not used for an extended time after being registered, its ID may be deleted.
Important
WX-CH457P_PUQX1020ZAV1.indb 33 2021/07/02 14:31:24