Panasonic X-Plus Series SP-DRH04 - Recording Schedules

27
values from each channel cannot exceed the maximum frame rates for
a specific recording resolution.
QUALITY
Select the recording quality for the specified channel. Options are:
LEVEL 1 (Low), 2, 3, 4 and 5 (High)
RECORDING
Assign the recording mode for each channel. Options are: Continuous,
By Motion, By Sensor, By Schedule or Disable.
SENSOR
RECORDING
Enable setting up to 4 sensors for the specified channel using the
mouse or the control button (◀ ▲ ▶ ▼) of the remote control.
PRE RECORD
Enable/disable pre-event recording. Options are: OFF, 15 seconds, 30
seconds, 1 minute, 3 minutes and 20 minutes.
POST EVENT
RECORD
Set the post event recording time duration for the specified channel.
(10~60 seconds)
AUDIO
Enable/disable audio recording for the specified channel.
 Fixed-available on only from channel 1 to channel 4.
SCHEDULE
Set the recording schedule. Press SEL to go to schedule setup screen.
3-3-1. Recording Schedules
To setup a recording schedule, select SCHEDULE in the RECORD menu. Navigate through the menu
items using the mouse or the control button (◀ ▲ ▶ ▼) on the remote control.
[Channel]: Select the specific channel.
[Setup]: Set up using the left button of the mouse to section under the specific day and time. It can set the
all section under the specific day or time at a time when pressing the specific day or time. It is also
possible to set up recording modes of various type using a Continue(green color), Motion(yellow
color) and Sensor button(red color). It can set easy using a drag-and-drop function of a mouse
control.
[COPY Schedule]: Set the channel 1 schedule and select the square button of CH2 in COPY SCHEDULE
section using the mouse. And, press the COPY button. Then the CH1 schedule is copied to CH2. To
remove the setting value, press the CLEAR button.