Select specified channel for motion zone setup.
Select either Full Zone or Partial Zone for motion sensing.
Set the motion sensitivity for the specified channel.
Control the motion sensitivity from 1(L) to 9(H).
Select the privacy zone through mouse drag (Left-up to right
down). To escape from this setting page, select Quite after
press the right button on the mouse.
Select an ID of remote control.
1. Select ID.
2. Press the same number as ID set in DVR on a remote control
3. Then icon will be displayed on Live screen of DVR that
respond to the remote control. The options are from 0 to 99
Select sensor Number from 1 to 4
Set the type of sensor for the specified channel. Options are:
OFF, N/O (normal open), and N/C (normal closed).
ON (Display 960x 576), OFF (Display 944 x 576). Select this
menu after checking the right inputting camera resolution
3-4-1. ALARM-OUT
Figure 3.4.2. ALARM-OUT setup screen
Table 3.4.2. Menu item in ALARM-OUT Setup screen
Available Number is just one (1).
Set the alarm dwell time from 5 seconds to infinite.
3-4-2 Controller & PTZ Setup
To control the PTZ functions of the camera, connect a controller to the RS-485 port.
① Connect the RS-485 cables of PTZ camera to the RS-485 port on the rear panel.
To Next Page
Loading...
