3-2. Setup – Display Mode
Press the SETUP button and select DISPLAY. Then, the DISPLAY menu displays as picture below.
Navigate through the menu items using the mouse or the control button (◀ ▲ ▶ ▼) on the remote control
and change the value of the menu item.
Figure 3.2.1. Display mode setup screen
Table 3.2.1. Menu items in DISPLAY mode setup
Enable/disable on-screen-display.
Set the visibility level of the On Screen Display (OSD).(50~100)
Enable/disable sequential display of video in full screen mode.
Set the dwell time of each, quad, 9 or 16 channels display in sequential
display mode.(3-60seconds)
Select a channel for applying the following settings using the mouse or
To Next Page
Loading...
