To escape from the motion zone setting mode, user has to click the right mouse button after finishing its
setup.
Figure 3.4.5. Motion Zone selection screen
3-5. Setup – Storage Mode
Press the SETUP button and select STORAGE icon. Then, the STORAGE menu is displayed as picture
below. Navigate through the menu items using the mouse or the control button (◀ ▲ ▶ ▼) on the remote
control and change the value of the menu item.
Figure 3.5.1. STORAGE setup screen
Table 3.5.1. Menu items in STORAGE Setup screen
When enabled, the DVR will continue recording and overwrite the
oldest existing recorded data once the hard drive is full. When
disabled, recording will stop once the hard drive is full.
To Next Page
Loading...
