INOXPAN S.L. EN - 8
1.6. SETTING THE TIME
When you plug the oven, you will see the clock flashing 12:00.
Press or to adjust the hours.
Press to confirm the hours.
Press or to adjust the minutes.
Press to confirm the minutes.
If you wish to modify the time, press or until the time starts flashing. Press and follow
the instructions in the previous points.
1.7.
HIDING AND UN-HIDING THE CLOCK
If you wish to hide the clock press for 5 seconds.
If you wish to see the clock on the display again, press for 5 seconds.
PROGRAMING THE BUZZER
1. Touch or until the symbol on the display starts flashing, then press The indication
“0_00” will appear on the display.
2. Select the time after which you want the alarm to sound by pressing or . You will hear 2
beeps to confirm that the time has been set and the clock will start counting down from the
selected time. The symbol will flash slowly.
Warning: This action must be done in no more than 5 seconds.
3. Once the time has expired, an acoustic signal will sound 3 beeps spaced at 30-second intervals
will sound 90 seconds and the symbol will flash quickly.
4. Touch any key to stop the alarm. The symbol will then disappear.
If you wish to modify the time on the buzzer, press or until the flash and the hours are
not flashing; then press and repeat the steps shown. Upon entering the timer control, the time
currently remaining will appear which you will be able to adjust
n the event of power failure, the clock settings will be erased and 12:00 will flash on the clock
display. Reset it and program again.
With the Buzzer function, the oven will not turn off when the time expires.
With the Buzzer function, the remaining time will show
permanently on the display. With this
programmed function, it is not possible to view the time or the total programmed cooking time.
When the oven is turned off, the internal fan can continue to run for a few minutes. This is normal.
To Next Page
Loading...
