33
U S E R M A N UA L
•To stop the engine, press the STOP ENGINE button on the control panel. In a few seconds the engine
will be stopped and the spinning
icon will be faded.
Mobile applications Pandora Online and Pandora Pro
•To start the engine, open the mobile application. When the system is online (there is an Internet or
Bluetooth connection) press and hold the START ENGINE button on the control panel until the scale
is fully loaded. In a few seconds the engine will be started, it will be confirmed with the spinning
icon.
•In a few seconds the engine will be started, it will be confirmed with the spinning
icon.
Service mode
It is recommended to put the system into the service mode before handing it to a car service or valet
parking. When this mode is switched on, security system stops interfering with built-in electronics and
disables all functions to ease maintenance.
To switch on this mode, disarm the system, turn on the ignition, an authorization device (a
radio tag, a Bluetooth remote control, a mobile phone) must be in the coverage zone, enter the
“Immobilizer PIN-code” (if the “Code immobilizer” function is used) and use one of the method
described below:
Radio tag
To activate/deactivate service mode, press and hold the
button on a radio tag for 3 seconds (until
the third flash of the LED), release the button.
Phone
Call the system number wait for the answer.
•To activate service mode, dial the
DTMF command and then dial the “Secret PIN-code” from
the Owner’s personal card.
•To deactivate service mode dial the
DTMF command.
Mobile applications Pandora Online and Pandora Pro
To activate/deactivate service mode, open the mobile application. When the system is online (there
is an Internet or Bluetooth connection), press and hold the
button on the control panel until
the scale is fully loaded.
!
TO CHANGE BUTTONS LAYOUT OR ADD NEW BUTTONS ON THE CONTROL PANEL, GO TO “SETTINGS CONTROL BUTTONS“.
To Next Page
Loading...
