PanoSpace I - Page 5

3
2.7 Settings...............................................................................................16
III. PanoBuilder
.......................................................................................18
3.1 Download and Install PanoBuilder......................................................18
3.2 Connecting Printer to PanoBuilder .....................................................18
3.3 Load Digital 3D Model Files into PanoBuilder ....................................19
3.4 Print 3D Models ..................................................................................20
3.5 Edit Digital 3D Models ........................................................................24
3.6 Load Filament .....................................................................................26
3.7 Unload Filament .................................................................................26
3.8 Adjust Level of Print Bed ....................................................................26
3.9 Adjust Gap ..........................................................................................27
3.10 Adjust Printer ....................................................................................27
3.11 Print 3D Models on SD Card ............................................................28
3.12 Calibrate Printer................................................................................28
3.13 Stop Printer.......................................................................................28
3.14 Settings.............................................................................................29
3.15 Update PanoBuilder and Upgrade Firmware....................................29
IV. Maintenance
......................................................................................30
4.1 Regular Cleaning ................................................................................30
4.2 Troubleshooting ..................................................................................31
V. Support and Services
........................................................................32