Pantum BM5100ADW Series User Manual

164
13.2. Software Failure
Problem
Solution
The printer icon will not be displayed in
the “Printer and fax” folder.
Reinstall the printer driver. Ensure that the USB interface
cable and the
The printer is in Ready mode but it will
not perform any print job.
If the failure still exists after restarting the Make sure the
network cable of USB cable is connected correctly.
Failed to install the driver
Check whether the print spooler service is enabled.
Check the power supply and the connection of the printer.
The driver cannot be used if the IP
address of the printer has been
changed
Modify the port IP address of the printer driver.
If the above method does not work, please reinstall the
printer driver.
It is recommended that a fixed IP address should be set to
the network printer.
In the DHCP network, it is recommended to bind the IP
address with the MAC address of the printer.

Pantum BM5100ADW Series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Duplex Printing	Automatic
Connectivity	USB, Ethernet, Wi-Fi
Monthly Duty Cycle	100, 000 pages
Processor	1.2 GHz
Memory	512 MB
ADF Capacity	50 sheets
Scan Type	Flatbed, ADF
Fax Function	Yes
Input Capacity	250 sheets
Output Capacity	150 sheets
Printer Languages	PCL6, PostScript 3
Copy Resolution	600 x 600 dpi
Scan Resolution	1200 x 1200 dpi
First Print Out Time	6.9 seconds
Toner Yield	3, 000 pages
Mobile Printing	AirPrint, Mopria
Print Speed	40 ppm (A4) / 42 ppm (Letter)
Copy Speed	40 cpm (A4) / 42 cpm (Letter)