Name: Pantum BM5100ADW Series
Brand: Pantum
Rating: 4 (1 reviews)

To Next Page

To Previous Page

6.2.1.2. IPv6 setup

1. Turn on printer power to connect printer to network.

2. Log in the embedded Web server (please refer to Chapter 6.1 for login method).

3. Click “Settings” – “Network settings” – “Protocol Settings” – “IPv6”.

4. Tick “Enable IPv6 protocol” and “Enable DHCPv6” (ticked by default) and then click “Apply”.

You can refresh the browser and view the “IPv6 Local Link Address” and “Stateful Address” in

“Wired IP Configuration” interface.

Note：

The printer supports using the following IPv6 addresses for network printing and

management(please refer to Chapter 11.4 and print “NetConf Pg” view IPv6 address).

• IPv6 local-link address: local IPv6 address set up by oneself (addresses beginning with

FE80).

• Stateful address: IPv6 address set up by DHCPv6 server (if there is no DHCPv6 server

in network, the “Stateful Address” cannot be assigned).

• Stateless address: IPv6 address set up by network router automatically.

6.2.2. Wireless setup

You can set up the wireless network, wireless IP setup, Wi-Fi Direct and WPS via wireless

setup page. Before setup, please log in the embedded Web server (please refer to Chapter 6.1

for login method).

Questions and Answers:

Need help?

Do you have a question about the Pantum BM5100ADW Series and is the answer not in the manual?

Pantum BM5100ADW Series Specifications

General