Pantum P2500 Series Maintenance Manual

6–10
M1 Paper feed failure
Possible cause
Solution
There is no electromagnet signal.
Check the electromagnet signal input to ensure that
the electromagnet signal line is normal.
The pickup roller is dirty.
Clean or replace the pickup roller.
Pickup roller wears down.
Replace the pickup roller.
M2 Continuous paper feed
Possible cause
Solution
Electromagnet signal error.
Check the electromagnet signal input to ensure that
the electromagnet signal line is normal.
The electromagnet spring hook
is not powerful enough.
Replace the electromagnet.
Incorrect assembly phase of the
clutch single set assembly.
Check the clutch single set to ensure that the
assembly phase is right.
M3 Tilt Feeding
Possible cause
Solution
The feeder channel is dirty.
Check the feeder channel to ensure that the channel
is clear.
The pickup roller is dirty.
Clean the pickup roller.
M4 Resend
Possible cause
Solution
Paper is placed incorrectly.
Confirm that the paper is placed correctly.
The separator is contaminated or
worn.
Clean or replace the separator.

Pantum P2500 Series Specifications

General

Print Technology	Monochrome Laser
Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	15, 000 pages
Input Capacity	150 sheets
Output Capacity	100 sheets
Connectivity	USB 2.0
Dimensions	337 x 220 x 178 mm
Processor Speed	600 MHz
Memory	128 MB
Print Speed	22 ppm (A4)
First Print Out Time	Less than 7.8s
Operating System Support	Windows, Mac, Linux
Media Sizes	A4, A5, A6, Letter, Legal, Executive
Media Types	Plain, Thick, Cardstock, Label, Envelope, Thin
Media Weight	60 - 163 g/m²