DIGIPLEX SERIES
AUTOMATIC REPORT CODE PROGRAMMING
When using either the Contact ID or SIA Reporting formats (see section [550] on page 27), the Digiplex system can
automatically program a set of default report codes. From programming mode (see page 2) enter any of the following
sections to set the indicated default report codes:
[790] - ALL CODES
Sets all report codes in sections [600] to [718] with the default values from the "Automatic Report Codes List" on the
next page.
[791] - ARMING & DISARMING CODES
Sets all report codes in sections [600] to [654] with the default values from the "Automatic Report Codes List" on the
next page.
[792] - ALARM & ALARM RESTORE CODES
Sets all report codes in sections [655] to [680] with the default values from the "Automatic Report Codes List" on the
next page.
[793] - TAMPER & TAMPER RESTORE CODES
Sets all report codes in sections [681] to [705] with the default values from the "Automatic Report Codes List" on the
next page.
[794] - TROUBLE & TROUBLE RESTORE CODES
Sets all report codes in sections [706] to [716] with the default values from the "Automatic Report Codes List" on the
next page.
[795] - SPECIAL CODES
Sets all report codes in sections [717] to [718] with the default values from the "Automatic Report Codes List" on the
next page.
NOTE: After automatic report codes have been set, you can still manually program the remaining report
codes or change some of the defaults.
To Next Page
Loading...
