Paradox SP6000 Installation Guide

Magellan & Spectra SP • Installation Guide
57
When armed, the PGM will pulse once every 30 seconds.
Option [6] OFF= PGM Pulse on any alarm disabled (default)
Option [6] ON= PGM Pulse on any alarm enabled
This option sets the PGMs to pulse on any alarm.
Option [7] OFF= PGM Pulse on any alarm Partition 1(default)
Option [7] ON= PGM Pulse on any alarm Partition 2
Program PGMs to pulse during an alarm for either partition. With this feature enabled, and in combination with the Follow Arm/Stay Arm/Sleep Arm PGM type, the
PGM will mimic the Arm LED.
PGM Programming
Sections [301] to [316]
The programming of the PGMs is accomplished in two steps:
1. Assign the PGMs to the panel.
2. Program the PGMs.
PGM Programming can be executed through the Installer Quick Menu in the programming guide.
Viewing the PGM Signal Strength
Sections [321] to [336]
Once PGMs have been installed and assigned to the panel, the signal strength of each PGM can be verified in sections [321] to [336]. Sometimes moving the PGM
or control panel by a small amount will greatly increase the signal reception.
How Do I Assign PGMs to the Panel?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (empty by default)
3. Enter the desired [
SECTION NUMBER] (from sections [301] to [316]).
4. Enter the 6-digit [
SERIAL NUMBER] of the PGM.
How Do I Delete Assigned PGMs?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (default 1111/111111)
3. Enter the desired [
SECTION NUMBER] (from sections [301] to [316]).
4. Press the [0] key six times to clear the serial number.
How Do I View a Wireless Transmitter’s Signal Strength?
1. Press the [
ENTER] key.
2. Enter your [
INSTALLER CODE] (default: 0000 / 000000) or [MAINTENANCE CODE] (empty by default)
3. Enter the desired [
SECTION NUMBER] (from sections [548] to [549]).
4. Press the repeater’s anti-tamper switch.
5. The keypad will illuminate numbers 1 to 10.
Signal Strength Indicator 8 to 10 / 3 beeps = Best signal 5 to 7 / 2 beeps = Average signal 1 to 4 / 1 beep = Weak signal (Relocate)

Paradox SP6000 Specifications

General

Partitions	2
User Codes	32
Event Buffer	256 events
PGM Outputs	2 (expandable to 16)
Compatibility	Compatible with wireless expansion modules and keypads
Communication	Phone line, GSM, IP
Users	32
Zones	Up to 32 (5 on-board)
Keypads	Supports multiple keypad types