DEVICE MAINTENANCE AND CLEANING
TRAINING
©Parata
How to adjust or replace the Perforation Blade
To adjust the depth of the cut, hold the anvil assembly with the wrinkle preventer spring facing
you. Loosen the 3mm Allen screw but do not remove. Turn the black twist knob on the end of
the anvil either clockwise or counter clockwise to change the blade depth.
Tightening the adjustment screw will result in a deeper cut, and loosening the adjustment
screw will lessen the depth of the cut. When you are finished, tighten the 3mm Allen screw
when your adjustment is complete.
To Next Page
Loading...
