Programming Your Application
6-11
650V AC Drive
MMI Parameters Table
Display Parameter Description Range Default
USE ABS
TORQUE
F
When TRUE, the direction of rotation is ignored. In
this case, the comparison level should always be
positive.
When FALSE, the direction of rotation is not
ignored. Driving a load in the reverse direction
gives a negative value for torque. In this case, the
comparison level may be positive or negative.
0=FALSE
1=TRUE
0
LOCAL MIN
SPEED F
The magnitude of the minimum setpoint that will
be used when running in Local Mode.
0.0 to 100.0 % 0.0 %
ENABLED KEYS
F
The following keys on the 6901 keypad can be
enabled or disabled separately. The combination
produces the parameter setting as in the table
below. The default of FFFF enables all keys.
0000 to FFFF FFFF
Parameter Setting RUN L/R JOG DIR
0000
0010
0020
0030
0040
0050
0060
0070
0080
0090
00A0
00B0
00C0
00D0
00E0
00F0
-
-
-
-
-
-
-
-
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
ENABLED
-
-
-
-
ENABLED
ENABLED
ENABLED
ENABLED
-
-
-
-
ENABLED
ENABLED
ENABLED
ENABLED
-
-
ENABLED
ENABLED
-
-
ENABLED
ENABLED
-
-
ENABLED
ENABLED
-
-
ENABLED
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
-
ENABLED
6511
When using the standard 6511 and 6521 keypad,
disabling the DIR key prevents the local setpoint
going negative (for reverse). Similarly, disabling
the L/R key prevents the drive being changed from
Local to Remote, or Remote to Local modes.
APPLICATION
LOCK
F
Setting this parameter to TRUE prevents editing of
parameter
P
1.
Set this parameter to FALSE to edit parameter
P
1.
0=FALSE
1=TRUE
0
DETAILED MENUS Selects Full menu detail when TRUE. The additional
parameters in the Full menus are indicated in this
table by F
0=FALSE
1=TRUE
0
To Next Page
Loading...
