Parker ac890 - Page 537

D-141 Programming
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Parameter Descriptions
L
INE COUNT X4
PREF: 133.27
Default: 0
Range:
_
Diagnostic showing the resolver position with a resolution of 65536 points per resolver division. This diagnostic is set to 0 at
power
-up and reset when RESET LINE COUNT is TRUE.
PULLEYBELT RATIO
PREF: 133.28
Default: 1
Range: _1 to 100
Set the ratio of Pulley Belt system between the
encoder feedback and the motor shaft ( Typically PARVEX Torque Motors ) .
Can be used either for resolver or ENDAT encoder.
Default value is 1 ( feedback mounted directly on the motor shaft )