5-1 890SD Standalone Drive
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
This chapter describes the mechanical and electrical installation of the 890SD Standalone Drive. It
discusses configuring your system, and how to turn the motor for the first time.
Follow the steps for a successful installati
on.
Step 1: Mechanical Installation
Mechanical Installation Diagram
Enclosure details
Mounting dimensions
Step 2: Connecting power
Step 3: Control connections
Control connection diagram
890SD Standalone Drive terminals
♦ Step 4: Checking the system
Power-up with 24V DC|
Configure the 890SD Standalone Drive
Set-up parameters
Step 5: Run the motor
Powering-up the unit
The Autotune feature
Initial start-up routines
To Next Page
