5-31 890SD Standalone Drive
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
4.2: Configure the 890SD Standalone Drive
You must now configure each 890SD Standalone Drive to your application. This is done using the DSE 890
Configuration Tool supplied on the CD, or the keypad.
Using the DSE 890 Configuration Tool
The DSE 890 (Drive System Explorer) Configuration Tool has a full Help system. Insert the DSE 890 disk
into your PC and follow the on-screen instructions. Use the tool to set-up the I/O connectivity so that it
meets the requirements for each 890SD Standalone Drive. When connected, enter the set-up parameters as
discussed on page 5-33.
Connecting to a PC
Connect the 890CD Common Bus Drive to your PC using an approved mini-USB lead. You can order this
lead from Parker SSD Drives: part number CM471050 (3m long) or CM465778 (1m long).
To Next Page
Loading...
