Operating the Drive
890CS Common Bus Supply - Frames B & D; 890CD Common Bus Drive and 890SD Standalone Drive - Frames B, C & D
Start/Stop and Speed Control
There are two forms of control in operation at any time: Start/Stop and Speed Control. Each can be
individually selected to be under either Local or Remote Control.
• Local or Remote Start/Stop decides how you will start and stop the drive.
• Local or Remote Speed Control determines how you will control the motor speed.
In each case, Local and Remote control are offered by using the following:
Local: The Keypad
Remote: Analog and digital inputs and outputs, RS232 Port or Technology Options
Note Refer to Appendix D: "Programming" - LOCAL CONTROL.
To Next Page
Loading...
