Chapter 3 Electrical Installation - 47 -
Motor Feedback Connector
Inputs for the resolver feedback, motor thermal switch, and hall effects are
located on the 15-pin Motor Feedback connector.
Figure 29 MOTOR FEEDBACK connector, female drive connector pinout
Important — Encoder inputs use a DS26LV32 differential line receiver.
Parker Hannifin recommends 26LS31 (or compatible) differential line driven
encoders.
Single ended encoders are not compatible.
Figure 30 MOTOR FEEDBACK connector, internal circuit diagram
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...