15 192-550002N10 ETH March 2019
In this chapter you can read about:
...................................................................................................................................... 15
...................................................................................................................................... 15
...................................................................................................................................... 15
Mounting ......................................................................................................................... 15
Electrical installation ........................................................................................................ 21
Motor/ gear assembly ...................................................................................................... 23
Read safety instructions (see page 7) before taking into operation!
The product is furnished completely mounted and mechanically ready-to-operate.
If no Parker drive is provided, attach your motor-gearbox combination according to
the instructions of the respective supplier.
The technical data must be respected.
Depending on the application, the operating company must provide for a suitable
separating safety fence. The access to the motion area of the ballscrew and
piston rod should be prevented during operation.
Before commissoning Safety instructions (see page 7) must be read!
The sound may vary from cylinder to cylinder. It depends on the motor/gearbox,
different drive options or on the production series due to different production lots.
Different sounds do not provide any hint as to the lifetime of the cylinder
Depending on the operating conditions (rotation speed, load, etc.) increased
surface temperature in the area of the drive may occur. When touching it during
operation slight injuries from burning may occur.
Don't touch the product during
2.1 Mounting
In this chapter you can read about:
...................................................................................................................................... 15
Mounting with mounting threads on the cylinder .............................................................. 15
Mounting with mounting accessories ............................................................................... 16
Mounting Instructions ...................................................................................................... 20
Do only use the appropriate mounting parts offered in the Parker product
catalogue for the respective mounting methods. These mounting parts are
especially designed for the ETH.
The cylinder housing must be mounted without tension or contortion.
The cylinder housing must be precisely aligned to the load direction of motion.
Occurring lateral forces on the cylinder must be taken into consideration.
2.1.1. Mounting with mounting threads on the cylinder
The easiest and most economic method of mounting is using the available
mounting threads on the cylinder body. Make sure that the mounting surface is
level and that the cylinder is mounted without tension and contortion. This method
of mounting is only possible, if the lower side of the mounting surface is accessible.
ETH100&125 does not have a mounting thread at the bottom of the cylinder.
Dimensions: please refer to ETH catalogue.
For cylinders in IP version, the cylinder is enclosed in a protective coating with
possibly not constant layer thickness. Therefore it can happen that when using
the front or rear mounting surfaces (only for parallel motor mounting) the
alignment of the cylinder deviates from the ideal 90° position.
To Next Page
Loading...
