Parker ETH Series - Accessory Mounting - Bearing Block; Mounting of Force Sensors; Mounting - Fixing of Accessories - Rear Clevis with Force Sensor

Commissioning
ETH Mounting Instructions
18 192-550002N10 ETH March 2019
2.1.2.3 Accessory mounting - bearing block
Tightening torques for the bearing block to be provided by the customer.
ETH032 ETH050 ETH080 ETH100 ETH125
0112.039
0122.039
0132.039
0142.039
0152.039
Part number
M8-12.9
M10-12.9
M12-12.9
M16 – 8.8
M20 – 8.8
Screw
37
66
83
200
320
Screw tightening torque (1) [Nm]
15
21
27
20
25
Minimum screw-in depth (2) [mm]
(1) torque controlled tightening
(2) when screwing into S235 JRG1 grade steel
Boundary conditions:
 Provide suitable washer under the screw head
 Joint area must be dry and free of grease
 We recommend to secure the screws with a liquid bolt retaining compound (e.g.
Loctite 242)
2.1.2.4 Mounting of force sensors
For mounting the force sensor please observe the attached operating instructions
respective for the force sensors!
2.1.2.5 Mounting - Fixing of accessories - Rear clevis with
force sensor
Customer’s screw tightening torques for the force sensor with rear clevis.
ETH
Pitch
Part number
Screw A2-70
Screw
tightening
torque (1)
[Nm]
Minimum
screw-in depth
(2)
[mm]
Deflection angle α
[°]
032
M05 0112.034-01
M6x20 8,1 9 3.5
M10 0112.034-01
M16
0112.034-02
050
M05 0122.034-01
M8x20 20 12 4
M10 0122.034-02
M20
0112.034-03
080
M05 0132.034-01
M10x25 38,5 15 4
M10 0132.034-02
M32
0132.034-03
100
M10/M20 0142.034-01 M16x50 130 14 4
125
M10/M20
0152.034-01
M20x60
270
18
4
(1) torque controlled tightening
(2) when screwing into S235 JRG1 grade steel
Boundary conditions:
 Provide suitable washer under the screw head
 Joint area must be dry and free of grease
 We recommend to secure the screws with a liquid bolt retaining compound (e.g.
Loctite 242)