Parker ETH Series - 5 Index

Parker EME
Belt / belt tensions
43 192-550002N10 ETH March 2019
A
Accessory mounting - bearing block • 18
Applications in accordance with the
Regulations • 7
Applications not in accordance with the
intended use • 7
B
Belt / belt tensions • 42
C
Checking the toothed belt • 39
Commissioning • 15
Conditions of utilization • 13
Cylinder mounting with mounting plates or foot
mounting brackets • 16
D
Device assignment • 5
Direction of the motor during extension of the
cylinder • 21
E
Electrical installation • 21
Exchanging the toothed belt (ETH032 ... 080) •
40
Exchanging the toothed belt (ETH100&125) •
41
F
For Safety Use • 7
G
General hazards • 7
I
Identifying Residual Dangers and Hazardous
Areas • 7
Introduction • 5
IP65 motor mount • 33
IP65 motor mount parallel • 34
L
Lubricating intervals and amount of lubricant •
36
M
Maintenance and service • 35
Maintenance schedule • 36
Motor / gear assembly with inline motor
configuration • 24
Motor / gearbox mounting with parallel motor
configuration • 26
Motor mounting for IP65 inline • 33
Motor/ gear assembly • 23
Mounting • 15
Mounting - Fixing of accessories - Rear clevis
with force sensor • 18
Mounting explanation • 6
Mounting Instructions • 20
Mounting of force sensors • 18
Mounting of the payload • 20
Mounting the rod guide (option R) • 19
Mounting with mounting accessories • 16
Mounting with mounting threads on the
cylinder • 15
P
Packaging, storage, transport • 9
Parallel mounting ETH032 ... ETH080
standard • 26
Parallel mounting ETH032 ... ETH080 with Ex -
Motor • 28
Parallel mounting ETH100 & ETH125 • 30
R
Re-adjust toothed belt pretension (new toothed
belt, all ETH sizes) • 32
Re-apply toothed belt pre-tension (reinsert the
same toothed belt, all ETH sizes) • 32
Relubrication via central lubrication port
(option) • 38
Relubrication via central lubrication port
(standard) • 37
S
Safety Instructions for Operating Personnel • 9
Safety Instructions for the Company Using the
System • 8
Screw tightening torques for the mounting of
the customer’s ETH cylinder • 16
Sensor mounting • 21
Sensors • 21
Setting the end limits • 22
Side Load • 20
Special notes on transport • 10
Supply repair • 42
T
Terms of guarantee / warranty • 13
Toothed belt • 39
Type identification plate • 5
W
Working safely • 8
5. Index