Motor/
29 192-550002N10 ETH March 2019
Mounting the EX-motor (ETH032... ETH080)
The ETH032, 050 and 080 Electro cylinders for parallel mounting of the EX motor
(ETH032 motor flange option K1B, ETH050 motor flange option K1D, ETH080
motor flange option K1J) are furnished with tensioned belt. When dismantling the
motor, the belt must NOT be detensioned.
Clean contact surfaces of motor, motor shaft, motor flange, hollow shaft bore,
clamping ring (please refer to Figure 23 Pos. 1)) and spacer sleeve (please refer
to Figure 23 Pos. 2).
Shaft, bore, clamping ring (please refer to Figure 23 Pos. 1) and spacer sleeve
(please refer to Figure 23 Pos. 2) must be free from burrs, dirt and grease.Push
the spacer sleeve (please refer to Figure 23 Pos. 2) in the hollow shaft bore up to
its stop.
Put the clamp collar (please refer to Figure 23 Pos. 1) onto the hollow shaft and
shift it up to the stop.
Align the slot of the clamping ring (please refer to Figure 23 Pos. 1) and the
spacer sleeve (please refer to Figure 24 Pos. 2) to the slot of the hollow shaft.
Align the hollow shaft so that the clamping screw (please refer to Figure 24 Pos.
4) stands over the opening of the flange.
Place cylinder upright, with the hollow shaft bore on top.
Push the motor vertically, with the motor shaft down, into the hollow shaft up to
the stop. Please take care that the motor connectors are on the right side.
For the next steps, leave ETH cylinder and motor in this position.
Insert and tighten motor fixing screws slightly (please refer to Figure 23 Pos. 5).
Insert and tighten clamping screws slightly (please refer to Figure 23 Pos. 4).
Tighten motor fixing screws.
Tighten clamping screw (please refer to Figure 23 Pos. 4) with the respective
tightening torque.
Close the opening in the motor flange with the lid (please refer to Figure 23 Pos.
3)
Tightening torques clamping screw:
To Next Page
Loading...
