Parker HAS Series - Connecting to the Drive; USB Cable Connection

Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois
www.parker.com/cylinder
Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
Catalog HY08-4005-M3
108
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
DSE Software
CylindersHybrid Actuation
System SSeerriieess HHAASS 550000
Catalog HY08-
DDSSEE SSooffttwwaarree
WWAARRNNIINNGG:: This product can expose you to chemicals including LLeeaadd aanndd LLeeaadd CCoommppoouunnddss which are known to the State of
PPRROOPP 6655 WWAARRNNIINNGG
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PPaarrkkeerr HHaannnniiffiinn CCoorrppoorraattiioonn
Cylinder Division
Des Plaines, Illinois
116
wwwwww..ppaarrkkeerr..ccoomm/
cylinder
•
CCoonnnneeccttiinngg ttoo tthhee DDrriivvee
There are now two ways to connect to a drive,
USB cable, and Ethernet.
The Comm Port icon is shown on the Left, and
the drop down menu is shown on the left.
UUSSBB CCaabbllee CCoonnnneeccttiioonn
At this point the only drive that can use the USB connection it
the 890 Drive. The USB cable is a standard type A to mini-B,
which should not be longer than 3 meters and of good quality
shielded cable. Connect the A connector to any open USB port
on the computer and the mini-b connector to the drive's X10
terminal. For a multiple drive systems linked via Firewire, please
refer to the DSE software manual.
In the Comm Port drop down list, there are two things that need
to be setup for USB communications; Comm port and baud
rate. Make sure there is a check mark next to the port number
that matches the port setup it the beginning of this chapter. The
baud rate should have a check mark next to Auto.
WWAARRNNIINNGG
Make sure all components on the system are properly grounded, BEFORE connecting any cables
to the drive or computer. Failure to properly ground the system will result in damage to the drive,
computer and cables.
Connecting to the Drive
USB Cable Connection