Parker HAS Series - 6511 Keypad Operation

Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
21
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois USA
www.parker.com/cylinder
Catalog HY08-4005-M3
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
6511 Keypad
66551111 KKeeyyppaadd ooppeerraattiioonn
The 6901 Keypad (Man-Machine Interface, MMI) provides for local monitoring of the drive. It is
useful for display of speed percentage and faults. It is not recommended for setting up the
Discrete Analog Drive configurations. The 6511 should be removed and 6901 should be used
for setup purposes.
TToo ddiissppllaayy tthhee SSooffttwwaarree VVeerrssiioonn::
Press and hold
to display software
version. Time-out or press
.
IInniittiiaall PPoowweerr--UUpp CCoonnddiittiioonnss
The keypad will display the Operator
menu Drive and 890SD Standalone Drive.
(Operation Menu)
Indicates the
Control Mode
Represents a rotating shaft: clockwise =
drive running forward anticlockwise - drive
running in reverse
Indicates numbers or values, trip
information, error codes etc. See
"Status Indications" below.
Indicates the drive is in Local control. Drive
is in remote control when not visible.
Displays the units for the value:
for current in Amps
for percentage
V
Hz
S
A
%
when displaying an Alarm code a
negative parameter value
for voltage in Volts, for
frequency in Hertz for
seconds
Indicates the
drive is in
Remote
Comms mode
PPaarrkkeerr HHaannnniiffiinn CCoorrppoorraattiioonn
Cylinder Division
Des Plaines, Illinois
18
wwwwww..ppaarrkkeerr..ccoomm/
cylinder
•
6511 Keypad Operation