Parker HAS Series - Resolver Card; Motor Phasing

Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
123
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois USA
www.parker.com/cylinder
Catalog HY08-4005-M3
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Resolver Card
MMoottoorr PPhhaassiinngg
The control of PMAC brushless motors is allowed if the relative position between the
stator and the rotor is well known. The resolver must be set up to define the relative
position between the resolver and the 3 motor phases. For the 890 drive, the
convention is as follows :
♦ when the motor runs in a clockwise direction, looking to the front shaft of the
motor, the 3 successive phases are M1, M2 and M3 as shown below.
♦ The resolver must be adjusted in a way to give a position of 0 degrees when the
M1 motor phase crosses the 0 Volt line in a rising variation. For example, a 6
pole motor associated with a 2 pole resolver will give the following curves:
-200
-150
-100
-50
0
50
100
150
200
0 90 180 270 360
position(degree) M1 phase
PPaarrkkeerr HHaannnniiffiinn CCoorrppoorraattiioonn
Cylinder Division
Des Plaines, Illinois
113
wwwwww..ppaarrkkeerr..ccoomm/
cylinder
Motor Phasing