EasyManuals Logo

Parker HAS Series User Manual

Parker HAS Series
125 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois
www.parker.com/cylinder
Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
Catalog HY08-4005-M3
4
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Risk Assessment
Under fault conditions, power loss or other operating conditions not intended, the
equipment may not operate as specified. In particular:
The motor speed may not be controlled
The direction of rotation of the motor may not be controlled
The motor may be energized
If the STO feature of the 890 drive is to be used, the user must undertake a risk
assessment for the application. The user must then verify that their design, which
includes the 890 drive, satisfies the Performance Level (PL) or Safety Integrity Level
(SIL) required by the risk assessment.
Under no circumstances must the STO feature be used without first reading and fully
understanding chapter 6 (Safe Torque Off) of the Engineering Reference Manual. All
safety warnings therein must be observed.
Accessibility
All live power terminals are IP20 rated only, since the equipment is intended to be
installed within a normally-closed cubicle or enclosure, which itself requires a tool to
open.
Protective Insulation
All control and signal terminals are SELV, i.e. protected by double insulation.
Ensure all wiring is rated for the highest system voltage.
NOTE Thermal sensors contained within the motor must be single/basic insulated.
All exposed metalwork in the Drive is protected by basic insulation and bonding to
a safety earth.
RCDs
Not recommended for use with this product. Where their use is mandatory, use only
Type B RCDs (EN61009).
Caution
This is a product of the restricted sales distribution class according to IEC 61800-3.
It
is designated as “professional equipment” as defined in EN61000-3-2. Permission of
the supply authority shall be obtained before connection to the low voltage supply.
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois
5
www.parker.com/cylinder
Hybrid Actuation System Cylinders
Series HAS 500
Catalog HY08-
Safety
Safety

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Parker HAS Series and is the answer not in the manual?

Parker HAS Series Specifications

General IconGeneral
Output Voltage0-Input Voltage
Control ModesTorque, Speed
FeedbackEncoder, Tachometer
Operating Temperature0°C to 40°C
Communication InterfaceRS485
Protection FeaturesOvervoltage, Undervoltage, Overcurrent, Short Circuit, Overtemperature
EnclosureIP20

Related product manuals