Parker HAS Series - Page 90

Hydraulic and Electrohydraulic Actuators
HAS Series Analog Drives Manual
91
Parker Hannifin Corporation
Cylinder Division
Des Plaines, Illinois USA
www.parker.com/cylinder
Catalog HY08-4005-M3
WARNING: This product can expose you to chemicals including Lead and Lead Compounds which are known to the State of
California to cause cancer and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
PROP 65 WARNING
Trip Table
The following Warning may occur to protect the drive and HAS System.
66551111
KKeeyyppaadd
DDiissppllaayy
66990011
KKeeyyppaadd
DDiissppllaayy
DDeessccrriippttiioonn PPoossssiibbllee RReeaassoonn ffoorr WWaarrnniinngg
88
wwwwww..ppaarrkkeerr..ccoomm/
cylinder
A 1
Reservoir over T
HAS Reservoir Over Temp
♦ System duty cycle too high, heat exchanger required
♦ HAS Relief PSI setting too low, operating at relief setting
Oil Change Req
♦ System has exceeded the recommended 8000 hours of
HAS Oil change Required
operation. Service Required.
A 2
Low Oil Level
♦ When fitted with low level switch, trip conditions low HAS
Low Level Condition
oil operating level
A 3
Temp Sens Fault
♦ Reservoir Temp not installed or cut cable
HAS Low Level Condition
♦ Damaged Reservoir Sensor
A 4
Default settings for above are warnings only, they will not prohibit operating of the HAS unit. Their purpose is to warn the user
of possible damage. Low level and High Temp conditions may be change to Trip drive. Keypad 6511 will display same code
regardless of Warning or Trip. 6901 will indicate Warning or Trip on Top line of display.
see page 71 for details.
Trips Table