Parker iqan-mc3 - 5 Mounting; Mounting the Module

20
Mounting the module
5 Mounting
Instruction book, IQAN-MC3
5 Mounting
Mounting the module
The IQAN-MC3 module should be mounted according to the following instructions:
• Locate the module eliminating the risk for the cabling to be folded, crushed or dam-
aged in any way. Ensure the cabling cannot pull, twist or induce sideload on the con-
nector.
• Locate the module so that severe physical impact is avoided, e.g impact from falling
objects or the module being used as a step.
• Locate the module so that air can circulat to eliminate excess heat. Ensure that no
external heat, e.g. from the engine or heater, is transferred to the module.
• Locate the module to protect it from high pressure washing or similar.
• For maximum cooling, mount the module on a vertical surface.
• Locate the module so that the LEDs are visible.
Recommended placing.
NOTICE
The IQAN-MC3 module must not be placed in any marine related or similar
continuously damp, salt-spray environment without external protection.