Maintenance and repair of the dryer
K-MT1-8_EN_08—2014 39
Maintenance and repair of the dryer
In order to allow maintenance work on the dryer to be carried out efficiently and
without danger for maintenance personnel, you should comply with the following
instructions.
Notes on maintenance
Warning!
Maintenance tasks may be carried out only by authorized and qualified
specialist personnel, and only with the plant in a switched off and
depressurised condition.
Note:
In order to ensure perfect maintenance and reliable operation we
recommend that you conclude a maintenance contract.
When exchange or replacement parts are ordered, always state the
dryer type and the build no. of the dryer. These data are found on the
type plate.
Carry out all maintenance work only when the plant has been shut down and
depressurised!
Bolt connections must be undone with care! Note ram pressure values!
Otherwise emerging media may cause personal injury.
Do not modify the factory settings of the control system in any way without
prior consultation with the manufacturer.
Never carry out any manipulations on a hollow profile vessel or modify the
same in any way!
Following maintenance work, always check all flange and bolt connections
for leakage and secure seating.
Never use pipes and fittings as steps or holding points! The components
might fracture, or the distortions which occur may cause internal damage on
the dryer. There is a risk of injury by slipping off the components,
components breaking off, and expanding compressed air!
Never leave tools, loose parts or cloths at or on the dryer.
Only use replacement parts that are suitable for the relevant function and
meet the technical requirements stipulated by the manufacturer. This is
always the case, if you use original replacement parts only.
To Next Page
Loading...
