The VMM1210 has 2 Delphi Metri-pack series 18-pin connectors, as follows:
White (J1): Mating Connector, Delphi Metri-pack 15492547; Contacts, Delphi
12103881
Black (J2): Mating Connector, Delphi Metri-pack 15492546; Contacts, Delphi
12103881
The connectors have pins that connect to inputs, outputs, network ports, and logic
power used by the VMM1210. They also have keying that prevents you from
incorrectly mating the connectors to the vehicle harness.
The following are images of the required mating connectors:
Figure 21: Connector J1
Figure 22: Connector J2
The VMM1210 also has 2 Delphi Metri-pack series 2-pin connectors for busbar
power (power for High-side outputs), as follows:
Black (J3): Mating Connector, Packard Metri-pack 12033769; Contacts,
Packard 12033997
Black (J4): same as above
To Next Page
Loading...
