Because every system is different, it is not feasible to provide detailed installation
instructions that will be suitable for every assembly. This chapter therefore
provides only high-level guidelines on installing the VMM1210.
The vehicle manufacturer is responsible for creating procedures for mounting
the VMM1210 in a vehicle during production assembly.
9.1. Mechanical Installation Guidelines
Use the following guidelines when installing the VMM1210 in a vehicle.
9.1.1. Dimensions
The following diagram shows the dimensions of the VMM1210:
Figure 24: VMM1210 dimensions
9.1.2. Selecting a Mounting Location
The VMM1210 can be installed in the vehicle's cab or on the chassis. If used in a
marine application, ensure that it is protected from excessive salt spray.
To Next Page
Loading...
