Parker Vansco VMM1210 - Page 60

50 VMM1210
Installation
The vehicle harness design depends on the following:
 How the VMM1210's inputs, outputs, communication, and power pins are
configured.
 Other components on the vehicle and their physical locations.
 The routing of the harness.
Suggested wire sizing for the various connections are as follows:
 Inputs, 18 AWG
 Outputs, 16 AWG
 Logic power and ground, 18 AWG
 Other powers and grounds, 16 AWG
 Busbar power, if applicable, 14 AWG per 20 A of current (or 8 AWG per 40
A of current for single pin busbar connectors)
Once the vehicle harness is designed, it can be connected to the VMM1210
simply by clicking the mating connector into the connector port on the
VMM1210.