Payne PH1Z024 - Page 27

START-UP CHECKLIST
(REMOVE AND STORE BNJOB FILE)
L PRELIMINARY INFORMATION
Model No .............................................................................................................................................................
Serial No ..............................................................................................................................................................
Date ......................................................................................................................................................................
Technician ...........................................................................................................................................................
Customer In_brmation(Name/Addre ss)
IL PRE-START-UP
Verify that all packing materials have been removed _kom unit
Verify that condensate connection is installed per installation instructions
Check all electrica! connections and terminals _br tighmess
Check wire proximity to refiigerant robes and sheet metal edges
Check that indoor (indoor) air filter is clean and in place
Verify that unit installation is level
Check _tll wheel propeller for location in housing and setscrew tighmess
III. START-UP
Supply Voltage: LIoL2 L2oL3 L3=LI
Compressor Amps: L i (C) L2(S) L3(R)
Indoor Fan Amps: O-indoor Fan Amps:
TEMPERATURE-( ooling Mode
Outdoor Air Temperature:
RemmoAir Temperature:
Cooling Supply Air: DB
PRESSURES-CooliI_g Mode
Refiigerant Suction psig
Suction Line Temp*
Re[iigerant Discharge psig
Discharge Tempt
TEMPERATURE-Heating Mode
Outdoor Air Temperature:
RemrnoAir Temperature:
Cooling Supply Air:
PRESSURES-Heating Mode
Refiigerant Suction psig
Suction Line Temp*
Refiigerant Discharge psig
Discharge Temp_"
DB WB
DB WB
WB
DB WB
DB WB
DB WB
Verify Refrigerant charge using charging rubles
Verify that 3ophase scroll compressor is rotating in conect direction.
*Measured at suction inlet to compressor
_'Measured at liquid line leaving outdoor coil
27