PBI CheckMate 3 - Login

PBI-Dansensor A/S COPYRIGHT © PBI-300042-B 10/2010
CheckMate 3 EN User Guide 15
2. Operation and Maintenance
Modes
The device can be in one of 5 modes:
Switched off Power supply disconnected.
Standby mode Display shows the Standby screen.
User has been logged off (if login is
required).
Sensor temperature is maintained.
Standby mode settings are set in chapter
"General setup" on page 37 - see side 37
for details.
Sleep mode Display shows the Sleep screen.
User has been logged off (if login is
required).
Sensor temperature is not
maintained.
Sleep mode settings are set in chapter
"General setup" on page 37 - see side 37
for details.
Ready mode Display will normally show the measuring
screen.
Sensor has correct temperature.
Measuring mode Display will normally show the measuring
screen.
Measuring has been started on the key.
While measuring the display will
continuously show measurement values.
When in “Manual spot” measuring mode a
progress bar is displayed in the bottom of
the screen.
Standby
13:46
08/17/06
Sleep
13:46
08/17/06
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product Menu
08/17/06 13:46
%
O
2
Bal
%
CO
2
Press to measure
0,482 29,5
70,0
Product: 47
Meat 400 gr.
Measuring mode: Manual spot
Product Menu
08/17/06 13:46
%
O
2
Bal
%
CO
2
0,482
29,5
70,0