PBI-Dansensor A/S COPYRIGHT © PBI-300042-B 10/2010
CheckMate 3 EN User Guide 29
Cleaning and Maintenance
General
Performing cleaning and maintenance regularly reduces the chances of equipment failure.
CAUTION! Personnel performing any maintenance or cleaning must familiarize
themselves with the "Safety Instructions" on page 9 before attempting any of
these procedures.
Cleaning
All of the device’s surfaces should only be cleaned using a mild soap solution and a wrung
cloth.
CAUTION! Never use hard tools or abrasive materials when cleaning any part of the
device.
WARNING! Never use cleaning agents containing chlorinated solvents or acetic or
phosphoric acid. These constitute a health hazard and could damage the
instrument.
Replacing measuring gas hose, filter and needle
During use of the device dust will over time be sucked through the measuring gas system.
The measuring gas filter
will therefore have to be replaced regularly depending on the
environment in which the device is used.
The needle
may sometimes touch the product being measured or the needle may suck
fluid from the packaging from which the measurement is taken. If this happens, it will be
necessary to replace both the needle and the filter.
If there is any dirt or fluid in the measuring gas hose
, it should be replaced or cleaned
using dry compressed air.
All of the parts can be ordered (and replaced) separately or as a complete kit.
See "Consumable parts and options" on page 54.
To Next Page
Loading...