PBI-300042-B 10/2010 COPYRIGHT © PBI-Dansensor A/S
34 User Guide EN CheckMate 3
Customer fields Select whether or not keying in of customer data before and/
or after the measurement is required.
Note data must be entered after the measurement if
required. In these cases Note required. Press will be
displayed in the bottom of the measuring screen.
You have the following options for Note settings:
(Only applies to products set to Auto spot or Manual spot
measurement)
Off Keying in of data will not be required.
If alarm Keying in of data will be required if
measurement raises any type of alarm.
If no alarm Keying in of data will be required if
measurement raises no alarms.
Always Keying in of data will be required after
each measurement.
Free Keying in of data is possible, but not
required.
In these cases Press to enter note will
be displayed in the bottom of the
measuring screen.
Press key to enter the data or press
key to skip.
Custom field 1-5 data must be entered before start of the
measurement if required. In these cases Data required.
Press will be displayed in the bottom of the measuring
screen.
You have the following options for each of the Custom field
1-5 settings:
Off Keying in of data will not be required.
Always Keying in of data will be required before
each measurement.
Once Keying in of data will be required only
before the first of a series of
measurements for the same product.
Each of the Custom fields can be named to show the
operator the type of data to be entered.
See "Custom fields setup ..." on page 41 for details.
New product
This function creates a new product with standard set-ups. The values can then be adjusted
to the desired product (see "Edit product" on page 33).
To Next Page
Loading...
