EasyManuals Logo

Pellas X S.Control User Manual

Pellas X S.Control
48 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #30 background imageLoading...
Page #30 background image
30
13. STRUCTURE SERVICE MENU
Service settings
Burner settings
Boiler settings
CH and HUW settings
Buffer settings*
Mixer 1-5 settings *
Output H mod A
Output H mod B/C*
Show advanced setup
Service counters
Restore service settings
Burner settings
Fire-up
Ignition test time
Flame detection
Firing-up airflow
Firing-up time
Blow-in inten. af. Infl.
Blow-in p. after infl.
Warm- up time
Stabilization time
Exhaust fan *
Vacuum*
Operation setup
Thermostat mode
Blow-in increase
Feeder 2 work
Feeder 2 min op.time
Feeder efficiency
Energy density
Max. power of burner
Medium power of burner
Min. power of burner
Tank capacity
Burning off
Burning off max. time
Burning off min. time
Air flush intensity
Air flush periody
Air flush interval
Air flush start
Air flush stop
Exhaust fan *
Vacuum*
Cleaning
Cleaning time .before inflame
Cleaning time burning off
Cleaning airflow
Exhaust fan *
Vacuum*
Supervision
Boiler power
Supervision time
Grate*
Flush time SUPERVISION
Flush period SUPERVISION
Lambda probe*
Operation with Lambda probe
Dynamics
Response time
Blowing correction range
Other
Min. blowing power
Fuel detection time
Max. burner temperature
Max. flue gas temperature
Additional feeder operation time
Exhaust fan
Min. exhaust fan power
Vacuum sensor
Min. vacuum
Max. vacuum
Boiler settings
Thermostat selection
Min.boiler temperature
Max. boiler temperature
Reserve boiler
Alarms
Boiler cooling off temperature
Parameters A, B, C, FL *
Pump off by thermostat
CH and HUW settings
CH activation temp..
CH stand.load.HUW *
Min HUW. temp *
Max HUW. Temp.*
Boiler inc.by HUW and Mixer
HUW oper.extension *
Circulation standstill time*
Circulation operation timei*
Exchanger*
HUW heat source*
Boiler
Buffer
Buffer settings
Buffer support
Loading start temperature
Loading end temperature
Start heating system*
Output H mod A
Output H mod B/C*
Boiler reserve

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pellas X S.Control and is the answer not in the manual?

Pellas X S.Control Specifications

General IconGeneral
BrandPellas X
ModelS.Control
CategoryController
LanguageEnglish