5
2. GENERAL INFORMATION
The controller is intended to control the
operation of a pellet boiler using an optical
flame brightness sensor. The controller is of
a compact design and it is easy to install.
It can control the work of central heating and
hot water circuits and also control the work
of 5 mixing heating circuits. The required
temperature of heating circuits can be set on
the basis of data obtained from the main
sensor. The possibility of cooperation with
room thermostats, separate for each heating
circuit is beneficial for maintaining
comfortable temperature in heating rooms.
Moreover, the device turns on the spare
boiler (gas or oil one)
The controller can cooperate with additional
steering panel located in living rooms and
additional module of lambda λ sensor.
Handling of the controller is easy and
intuitive. The controller can be used within
the household and in small industrial
buildings.
3. DATA REFERRING TO
DOCUMENTATION
The user’s manual of the controller is a
complementation of boiler documentation. In
particular it is necessary to apply the boiler
documentation. The user’s manual of the
controller is divided into two parts: for the
user and for the installer. However in both
parts vital information concerning safety is
included. That is why the user should get
acquainted with both parts of the user’s
manual.
We do not take responsibility for damages
caused by failing to observe the following
user manual.
4. DOCUMENTATION STORAGE
We advise you to keep carefully this user
manual of installation and maintenance and
all other valid documentation, for immediate
use when needed. In case of removal or
selling the device all the documentation
should be handed to new user or owner.
5. SYMBOLS AND MARKINGS USED
Following graphic symbols and markings are
used in the user manual:
-for relevant information and tips,
-for vital information related with
issues of property damage, health
and life risk of humans or domestic
animals,
Attention: by these symbols vital information
is marked. It is to allow easy understanding
of the user manual. User and installer is
however required to observe
recommendations not expressed by graphic
symbols!
6. WEEE 2002/96/EG ELECTRICITY
AND ELECTRONICS BILL
The packaging and product is to be
utilized at the end of using period by
a proper recycling company.
The product can not be disposed
together with ordinary wastes.
The product can not be burned.
To Next Page
Loading...
Need help?
General