1
2
3
4
ALWAYS READ THE PELLENC SELION M12 CHAINSAW USER GUIDE CAREFULLY BEFORE USE
• To start your Pellenc pruner, turn on the battery by pressing the ON/OFF button (1) for 1 sec, the red
LED (2) will light up, then the battery will beep 4 times. The pruner is ready for use, press the bottom
trigger, then release it, the blade opens (the opening and closing of the blade are proportional to the
movement of the nger).
• To stop your pruning shears, close the blade, using the trigger, and keeping it closed, press on the
switch (1). The battery beeps once and the red LED (2) goes off.
• The pruning shears stop closing if the cut required is too hard. They can then only open.
• To put the pruning shears in "standby" mode, press the trigger and hold it closed for about 4 seconds.
• If the trigger is not operated for one minute, the tool automatically goes to standby; press the trigger
again to leave standby mode.
• To start your Pellenc Selion M12 chainsaw, turn on the battery by pressing the ON/OFF button (3) for 1
second, the green LED (4) will light up and ash. Put the pruning shears in standby mode and the green
LED (4) stays on steadily. The Pellenc Selion M12 chainsaw is ready to operate.
USE
• You must take all necessary care to prevent catching the lead of the pruning shears in the branches. To
do this, attach the lead to your arm using the wrist strap provided. (see page 13 or 15)
• The operating time and service life of the pruning shears mainly depend keeping the blade properly
sharpened and adjusted.
• It is essential to remove the burrs (wire edge) from the cutting edge of the blade, and to le it off within
the rst 15 minutes of use.
• We recommend that you do not disconnect the lead of the pruning shears from the battery unit after use
each day, but wind it around the "battery" unit and replace them both in their carry-case.
ADVICE FOR USERS
USAGE METHOD WITH BOTH TOOLS
For safety's sake, when the pruning shears and chainsaw are both connected, the shears have priority.
• When the shears are operating, there is no power to the chainsaw.
• When the shears are on standby, the chainsaw is powered.
So there is no need to use the ON/OFF switches to start and stop the tools.
Right side :
Reserved to pruners (Prunion
/ Vinion)
Left side :
Reserved to Selion M12
Pruner - Chainsaw
To Next Page
Loading...
