7
SAFETY MEASURES WHEN USING THE "PELLENC" CHARGER
1– During operation, the charger temperature can reach 60° C. There must be no ammable material within
1.5 meters of the charger and the battery.
2– Place the charger out of children’s reach and onto a non-combustible support.
3– Do not interfere with its cooling cycle.
4– The charger delivered with the is intended for charging it. Do not charge non-rechargeable batteries.
5– The charging location must be equipped with a class D re extinguisher (for metal re) in good working
order.
6– If the output cord is cut or damaged, bring the entire charger back to the authorised distributor where the
tool was purchased.
7– Only recharge using the "PELLENC" charger indicated by the manufacturer. A charger adapted to one
type of battery unit may present a re risk if used with a different battery unit.
8– This charger is designed to charge the batteries of Pellenc's lithium tools.
9– Do not use it for any other purposes.
10– Children must be supervised to ensure they do not play with the charger.
11– Verify that the cable cannot be folded and does not touch hot surfaces or sharp edges.
12– Ensure good ventilation during the charge.
13– Never cover the charger.
14– This charger must not be used outdoors.
15– Make sure the power connector is not exposed to water.
16– Never charge a damaged battery.
17– Grid connection must comply with national electrical regulations (EN60204-1).
18– Check the cable of the charger before using it. Never use the charger if the cable is damaged
19– When the battery is charging, place the charger on a non-ammable support, more than 1.5 m away
from any ammable object.
SAFETY INSTRUCTIONS
To Next Page
Loading...
