EasyManua.ls Logo

pellenc Prunion - Introduction; Safety; General Safety Instructions for the Electrical Tool

pellenc Prunion
34 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5
32_15_001A
OFFOFF
32_15_002A
ONON
SAFETY INSTRUCTIONS
SAFETY WARNINGS FOR BATTERY-POWERED SHEARS
1– Never modify the connector in any way whatsoever.
2– THIS TOOL MAY CAUSE SEVERE INJURIES. Read carefully the instructions relative to the proper
handling, operation, maintenance, start-up and stop of the tool. Familiarize with all its controls and proper
use.
3– Always switch off the battery when the machine is not in use (both LEDs must be off).
4– Make sure that the blade is not in contact with any object before starting the tool.
5– Never use the tool if it is damaged, incorrectly set or incompletely assembled.
6– Never remove or disable a safety device. Have the safety device repaired if is faulty.
7– Never disconnect the power cord of the tool without having checked that the red and green LEDs on the
left and right of the battery display are off.
8– Never carry the pruning shears suspended from the power cord.
9– Do not disassemble the pruning shears.
10– Do not try to cut pieces of wood that are too large or other materials than wood.
TOOL USAGE AND MAINTENANCE
1– Do not force the tool. Use the tool suited for the job.
2– Do not use the tool if the switch does not allow it to be switched on and off.
3– Disconnect the battery pack from the tool before making any adjustments or changing accessories.
4– When not in use, keep tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate it.
5– Comply with the tool servicing instructions. Check that the moving parts are not out of alignment or
jammed, that there are no broken parts or that there is no other condition which could affect the operation
of the tool. If damaged, have the tool repaired before using it.
6– Keep the cutting components sharp and clean.
7– Use the tool, accessories and blades, etc. in accordance with these instructions, taking into account the
working conditions and the work to be done.
MAINTENANCE AND UPKEEP
1– Have the tool serviced by an authorised PELLENC distributor, using only identical spare parts.
Figure 1: Battery off (2 LEDs off) Figure 2: The battery is on (red LED and
green LED lit)

Other manuals for pellenc Prunion

Related product manuals