CHANGING BLADE OR SHAFT
ATTENTION: Never operate the pruning shears without the blade and shafts, as this will cause
damage to the ball screw and the body of the shears.
1– Remove the adjustment washer
2– Remove the clevis pin and replace worn parts.
3– Replace the blade on the hook after greasing the seating, then replace the blade shaft and the clevis
pin.
4– Replace the adjustment washer and locking blade.
5– Tighten the wheel on the blade shaft.
6– Clip the guard in place again by pressing on its centre.
7– Tighten the blade shaft, as instructed in the previous section.
8– Reconnect the pruning shears.
To Next Page
Loading...
